GOODMAN MAIN STOPPER MFG. CO., INC.

THE GOODMAN-PEDEN STOPPER

In the GOODMAN-PEDEN STOPPER the flexible frame, padding, covering and diaphragm of the Goodman Stopper remain in principle, but the handles have been discarded. In their stead, a new arrangement in construction makes it possible to operate the Stopper mechanically, rather than by the experience and skill of the workman. Made in standard sizes. Special sizes to order.

HOW TO USE THE GOODMAN-PEDEN STOPPER

When you first use the Stopper, practice with an empty pipe. Insert the Stopper in the main through a tap hole in the usual manner. The supporting arm follows into the hole. Clamp the top wall of the pipe between the lugs and make rigid and firm by tightening set screws.

In the smaller sizes (up to 10") pull the cable handle tight, thus causing the Stopper to move upward and forward, the top part sliding along the surface of the upper part of the pipe; at the same time the Stopper is expanding into shape and stopping the flow in the pipe. Tighten set screw against the cable or drum, thus locking the Stopper in place.

On sizes 12" and over, wind up the cable by using the crank handle; tighten set screw against drum.

TO REMOVE STOPPER

Release cable at set screw, also release Stopper at set screw at tap hole. Then place lower part of bottom lug on the top of the pipe and push forward on the supporting arm, using it as a lever. This will release the Stopper in the pipe and it may be withdrawn in the usual manner.

After using, the Stopper should be wiped clean. Store in a cool place. Wrap in an air-tight cover.

TAPS

For	2-inch Stopper	3/4 -inch Hole
For	3-inch Stopper	1 -inch Hole
For	4-inch Stopper	1-1/4 -inch Hole
For	5-inch Stopper	1-1/4 -inch Hole
For	6-inch Stopper	1-1/2 -inch Hole
For	7-inch Stopper	1-1/2 -inch Hole
For	8-inch Stopper	2 -inch Hole
For	9-inch Stopper	2 -inch Hole
For	10-inch Stopper	2 -inch Hole
For	12-inch Stopper	2-1/2 -inch Hole
For	14-inch Stopper	2-1/2 -inch Hole
For	15-inch Stopper	3 -inch Hole
For	16-inch Stopper	3 -inch Hole
For	18-inch Stopper	3 -inch Hole
For	20-inch Stopper	4 -inch Hole
For	22-inch Stopper	4 -inch Hole
For	24-inch Stopper	4 -inch Hole
For	30-inch Stopper	4 -inch Hole
For	36-inch Stopper	5 -inch Hole
For	42-inch Stopper	5 -inch Hole
For	48-inch Stopper	6 -inch Hole

Gas Main Line Pressure must NOT exceed 12 in. W.C.

ALWAYS use two stoppers in series with a vent pipe between them.
See illustration in the catalogue.

Top of Page

Contact Information

Please call with your requirements, or fax us a blueprint or sketch for a prompt quotation on price and delivery.

Goodman Main
Stopper Mfg. Co. Inc.
523 Atlantic Avenue
Brooklyn, NY 11217

Telephone: 718-875-5140
Fax: 718-625-4805

Email: rubcons@ix.netcom.com